KnifeForums.com - Intelligent Discussion for the knife enthusiast
Username Post: Lanyard hole
Gimpy
Journeyman KnifeNut!
*
12-03-11 14:57.57 - Post#2416519    
    In response to MikeStewart

@MikeStewart-Yes, they have. If you think I over think things then you should meet my dad lol. And I make my knives individually and put around 15-20 hours in each knife. I have blood, sweat, and time into each one. The reason why I want to flare the ends of the tubing is because I want it to last and stand up to rough use. A mechanical bond is alot stronger than a chemical bond. Thank you very much for the information. Do you know anywhere that I can get a chamfering tool? Also, would you mind posting your website if you have one please? Thanks!
@Nasty-I agree with you on the issue of just breaking down the edge. Lanyard holes, in general, aren't used every time the knife is used or even often.
@Lonepine-I have never used tubing for a lanyard hole, but I believe copper and brass should be what you start with because it is a little easier to work with. My client told me that she wanted bolsters on the end instead of the tubing.
Thanks to everyone for all their help!
NOTE: You are viewing an individual Post. View the Entire Topic
KnifeForums.com - Intelligent Discussion for the knife enthusiast
KnifePromotions

arenaro@verizon.net

FusionBB™ Version 3.2 | ©2003-2014 InteractivePHP, Inc.
Execution time: 0.294 seconds.   Total Queries: 38   Zlib Compression is on.
All times are (GMT-12.0). Current time is 02:11.30
Top